LXSeries Lighting Software

Hi Claude,

I often find myself selecting all layers one after the other (especially when importing dxf) or turning them on and off.
Are there any shortcuts to do this ? (like "Select all" or "ON/OFF")

In addition : when saving views the "dim" parameter applied to a layer is turned to "on" when the view is recalled. Which sometimes makes the view more difficult to read.

Thanks !!!

Pierre

The dim state of layers is saved along with a user defined view. So, if the layer was dimmed when the view was saved, it will be dimmed when the view is recalled.

To be clear, you want a shortcut to make all layers either on or off?

Hi !

To be clear, I'd like
- a shortcut to "select all layers"
- a shortcut to turn them all to on / off / dim
Buttons at the top of the column perhaps ?